What are the common problems encountered by color steel tile presses?

The color steel tile press equipment inevitably encounters such problems during the production process, commonly the deviation of color steel plates, which can affect the production efficiency and product qualification rate of the machinery. Therefore, we should know how to correct these errors. After a long period of research and exploration, we have come up with a method to adjust this issue:

If the equipment board runs to the right, we need to use iron blocks to pad the left corner or flatten the right roller. If the third axis deviates, it will flatten out. The upper drum should be consistent with the lower drum. If the top is flattened, the bottom should also be flattened, and the symmetrical drum will not change. If it still doesn't work, first adjust the four equal corners of the mechanical front and rear rows of the color steel tile press from the large frame to a position with the same height as the upper end of the bottom shaft. From the arrangement to the back row, find the line straight and check if the lower shaft is on the horizontal line. Adjust the left and right sides of the lower shaft to be level.

Daily usage regulations for color steel tile press:

1. Electricians are familiar with the types and performance of factory circuits and electrical equipment. If they do not fully understand the performance of electrical equipment, risky operations are prohibited.

2. Electricians should regularly check the condition of equipment such as cables, motors, and control consoles every day. If any problems are found during the inspection, they should be dealt with in a timely manner. When checking the temperature of the motor, first check for no power and then test with the back of your hand.

3. Partial power outage operations, located 0.9 meters or less away from the electrical inspector, require temporary shelter with dry wood, rubber, or insulation materials.

4. When using electric tools, there is protection against electric shock.

5. Except for temporary construction electricity or temporary measures taken, it is not allowed to install temporary wires, hang lights at will, use switches and sockets for instruments, tools, welding machines, and other applications, and change original wires at will.

6. When any conductive part of the equipment is found to be grounded, it is not allowed to approach except for rescuing the person who has been electrocuted before turning off the power. It is recommended to stay away from the surrounding area for 4 meters and indoors for 1.8 meters to avoid damage from step voltage.

7. Regularly inspect and maintain electrical equipment according to regulations, and remove unused electrical equipment circuits.

8. When using a ladder, the best angle between the ladder and the surface is 60 degrees. When using a ladder on a cement surface, measures need to be taken to have someone support the ladder.

9. When repairing color steel equipment, the switch and switch blade should be pulled down, and warning signs prohibiting contracts and work should be hung at the switch and switch blade. Warning signs for stopping and high voltage danger should be hung at passages where live equipment is blocked or prohibited from passing, and warning signs for working in this area should be hung at the workplace.